how to decide the ratings of the busbar in
electrification.give me the proper thumb rule or procedure
- 1 Answers
- 4109 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / kannapa
busbar I = 1.4xtransformer kva this is apparent power.
busbar I = 1.74xtransformer kva this is for load in kw.
actual this is on low votage i.e., 415v 3phase only.
p=1.732xvxI from this we can obtain for different votages
and power ratings.
v may be 11kv,415,220v etc
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
how to check three phase motor torque value?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
what will be project cost for 100 kv transformer connection under oyt scheme.
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
Define ohm’s law for a.c (alternating current)?
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
What is different bewteen low or high impedance busbar protection scheme
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
a starter used for squirrel cage induction motor?
Draw the circuit of clapp oscillator?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
What does the kvar means?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
