How can we calculate the power factor of an electrical
appliance ?
Is there any formula ? Is there any meter around to
calculate it ? And how to use that meter ? thanks
- 2 Answers
- 5762 Views
- Essar, Philips, I also Faced
- E-Mail Answers
Answer Posted / shyam
power factor can be calculated by formula =kw/kva.
there are power factor meters avilable to measure the power
factor direclty of an equipment.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is the max. acceptable leakage current in 33kv bus bar
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
What does a Bode plot tell you?
hai iam arunkumar. i have applied for an section enginner in rrb. i want lat 5 years solved question papers. if u have please sedn it to arun30682@gmail.com
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
What types of high speed CMOS circuits have you designed?
What is hipot test procedure?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
what is mean by Digital Logic Meter (DLM)
What type of DC motor would you see for a lift?
Write a note on Treatment for electric shock.
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
