What is the difference between compensation and extension cable.
- 11 Answers
- 34500 Views
- HPCL, I also Faced
- E-Mail Answers
Answer Posted / ali
compensation used for RTD sensor ,becaus the wire have resistane and to compensate the lose of the wire we should make copensation circuit.
but the extension is different ,just to extend the cable and we can use it at any connection
| Is This Answer Correct ? | 5 Yes | 16 No |
Post New Answer View All Answers
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
Explain the working of an electronic level troll.
Explain pH, Conductivity.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
How we connect a instrument with ground, Give brief explanation with help of diagram?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
In turbine what does term CDP, NI, NH, HSSOC means.
Why thermo wells are used? What materials are used in thermo wells?
how to relay switch sense the fault?
what is a half wave, full wave, and bridge rectifer.
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
what is the responsibility of an instrument commissioning supervisor
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
