Answer Posted / abhi...
In dc there is no phase difference between current& voltage
(is zero) so.........
power factor= cos(angle between vtg and current)
here angle = zero
therefore power factor = 1
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
What is current & voltage ? Voltage perform at any load without current or not?
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
What is relation between mu(nought) and epsilon(nought)?
in star-delta tranformer,if the input of star connection is 400/7v 3 kva then what is the output of delta connection?
how to calculate the earth fault current
What is the test block protection relay if any body know plz explained
how to check regenerative load in drived motor
What is dielectric loss?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
how does high earth to neutral voltage affects electronic circuit?
