what is the use of choke on tube light fitting
- 37 Answers
- 72251 Views
- Bhel, Dharma, HSBC, TCS, I also Faced
- E-Mail Answers
Answer Posted / ravi.p 08-236 svec
to glow the tube light ionization of gas in the tube is
very important for this huge amount of voltage is
required.due to choke is an inductor it doean't allows the
sudden change of voltage and it stores the voltage in the
form of electromagnetic field,that huge amount of storage
voltage(1000-1100)v supplied to electrodes of tube to
ionization of gas at the time of starting in sec's.after
that it bring out the starter to out of circuit.and the
tube light glow continued with half of the supply voltage
(50-60)v.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define reserve-generating capacity?
What is polar plot?
when it is possible kvrah lead & fundamental kwh be equal in electonic trivector meters (3 ph)
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
for hipot test on 33kV busbar, we will test on 70 kV or 56kV, what is the acceptable leackage current?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.
what is inter connected dc generator?
how to calculate insulation level of transformer?
Details about Flux Compensated magnetic Amplifer starter for motors
what is strip power factor?
why cable i burning without tripping. how can protect led street lights
What are the factor to be consider for CT selection in 132kV substation?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
