Answer Posted / k.prakashchandra
As the voltage is high ,the current is less.So ,instead of
having 3 windings of line voltage ,you can have 3 windings
of phase voltage to save on insulation and others.Iron
losses are also reduced.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
what is consequences of neutral and earth connect?
what is the difference between STAR and DELTA connection and application wise how it can be utilizedd
Why two phase welding machine is used instead of three phase welding machine.
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
can u give me a brief idea about power line carrier communication ??
why i can not use thimble on capacitor duty contactor
How to test lightning Arrester?
A parallel flow heat exchanger will perform better than a counter flow heat exchanger. State if the statement is true or false.
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
what is destructive and non-destructive testing of welding
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
