Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the minimum depth of ground laid 66 kv ht
cable?
- 3 Answers
- 8171 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / srinivas
The minimum depth of ground laid 66kv ht cable is 1.5mtr.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is the difference between Static and servo controlled voltage stablizer?
Can anyone explain me about the capacitor calculation
list the type of vfd? wich is sutable for heating kiln?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
How to size Air Circuit breaker (ACB)? What is the most important factors?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
draw the block diagram of fire alarm?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
what is the relationship between current&voltage in practical purpose ?
