How much voltage we get between two wire of 4 to 20 ma
output? Is this voltage up or down respectvice to 4 - 20
ma ?
Answer Posted / karthick
Transmitter required 5V for display the parameter
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
how works encoder in plc
What is the procedure of calibration of Load cell?
How flow can be measured with dp?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How to Calibrate Vibration Probe (Axial, Redial) in field
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
What is super thermocoupal?
which type of zones used for boiler? & why ?
what is the difference between -24 : +24 & 0:24 and where it use?
can you provide me full detail about instrumentation in ONGC??
What is stripper & spilitter ? Diffrence in this.?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
What is difference between ESD and PLC please Explain me clearly.