what is difference between accelerometer vibration sensor
and proximity vibration sensor
Answer Posted / ch amir islam
There is no diffrence b/w these sensors thier method of
sensing is same depend upon the EDDY currunt
losses.ACCELEROMETER & PROXIMITY are diffrent way to
measure the vibration although they have same sensing
method as i told before.
Is This Answer Correct ? | 6 Yes | 15 No |
Post New Answer View All Answers
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
How to Calibrate Temperature Switch in field
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
Which type of pressure can be measured by these elements?
what is the difference between scaler and vector drive
what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.
Why plc require in analog input 4-20amp & 0-10 volt?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
Explain working principle of lvdt?
Why flow/pressure transmitter before control valve?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
What are the types of control valves available
What is sensitivity in vibration probes..?