Answer Posted / gurmurat
the main purpose behind using CT,pt is to prevent the circuits from overcurrent,undervoltages nd earth faults
they step up/down high values of currents and voltages under measurements into desired values which could be measured by available instruments.
Is This Answer Correct ? | 7 Yes | 8 No |
Post New Answer View All Answers
How to determine alternating current frequency?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
What is Diff btw Fire Alarm & VESDA System???
why generator efficiency is more in swinburnes test?
Define de-sensitivity?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
what is under coal gassification?
What is the abbreviation of NGT panel
33kv substation lay out details & line to line & line to earth measurements
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
what is PID control in VFD drives?
where we use the SFU & FSU?
What is the difference between diesel generator engine with and without turbo charger with the same capacity?