Answer Posted / denizen360

hook up drawing is a which represent the connection between
the instrument and process line..
which is used to prepare bill of material..
2 types of hook up are there..
1.pneumatic hook up
2.process hook up

source: http://instrumentpedia.blogspot.com/2010/12/what-is-
hookups-drawing-and-how-to-read.html

Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?

1771

---

What is rang ability?

1792

---

in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.

2295

---

In Safe Guarding test what means by "Failed to Danger" ?

1657

---

How to erection of DCS Panel at site step by step

999

---

---

how the arrangement of equipments done in control room

1592

---

What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?

3006

---

Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com

1691

---

Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?

1367

---

Draw block digram for well head from well to shipping pump?

1742

---

Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?

1916

---

i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure

1450

---

what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail

1323

---

what are the diff. in servo and regulatory control?

3474

---

What is three element in drum level?

930

---