what is the purpose that we use PLC system in power system
- 2 Answers
- 4198 Views
- Glatt, MTS, I also Faced
- E-Mail Answers
Answer Posted / teja naidu
Power Line Communication(PLC)system is used in Smart Grids,
to provide good communication network to receive information
and control the loads of each costumer in real time.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
Please send 110 kv sb station full single line drawing(sld)
What Maximam Gap Taibaar & Bush
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
What is a signal flow graph?
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
How Diesel Generator start ?
What is servo motor and what are different types of servo motor
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
what is the difference between c power and U power acb breaker
