WHAT IS REMOTE CONTROLLED DG? WHAT IS DIFFERENCE BETWEEN
REMOTE CONTROLLED DG & NORMAL DG SETS

Answer Posted / s .karmakar

In remote start DG set we need a controller by which we can
send command to the dg set to start(by making a "NO"
contacrt "NC" ) depend on our requirment.

Is This Answer Correct ?    0 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?

1592


Explain Energy and Power signals?

1282


with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen

1404


i m in need of current rating chart of heavy duty pvc/xlpe, cu/al cables. can somebody provide me? if yes, plz send me at ashish_patel111@yahoo.com

1526


What is the cut-off rate?

714






How to calculate that clean water supply in one Day from 150 KLD STP?

1562


Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors

1450


How phase to phase voltage comes 440V.

1456


What is servo motor? what is its purpose?

1595


A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE

2073


What is an alternator impedance value?

2406


how can we select the appropriate VCB ?

1826


What is the general system requirement of alternator?

1325


at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.

1182


Salient pole alternator is more stable, why?

2082