Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any interfacing sofware to build communication
between a PC and ER300P model L&T make trivector meter via
RS485 port which is available in the meter and is there any
data acquisition card available to store the acquired data
from the meter into the system
- 12 Answers
- 22240 Views
- I also Faced
- E-Mail Answers
Answer Posted / siva kumar
Hi george, i am siva, i have L&T Trivector Meter ER300p, Can
u guide me how to take data from the meter
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?
How to calibrate Toxic gas detector?
How to measure the dust in chimney(spm)?
full process of gas turbin?
what are the selections available in configuring a burnout protection of a controller? thanks
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
What is the GK Value in Flowmeter?
what is output of FOUNDATION FIELD BUS transmitter
why we take %i0.0 as input for twido plc
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
give me the formula for analog to digital converter and also d to a converter
Boolean algebra
What is the use of each wire in three wire RTD
How r the calculation of process line mpm.
