what material used made for the resistance,for the purpose of
zero temperature coefficient?
Answer Posted / 9014522170
magnanin
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
How to calculate the fuel consumption for 600kva DG genset which connecting with 25%load?
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
what's the exact magnitude of current, flows through Neutral?
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
What do you mean by ratio correction factor of instrument transformer?
List out the different frequency domain specifications?
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??