Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / baha al
There are three type of earthing:
1- TN-C-S earth and neutral combined in the supply network
but separated in customer installation.
2- TN-S earth and neutral run back separately to the
transformer neutral terminal.
3- TN-C earth and neutral are combined right throughout the
installation
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
Define open loop control system.
-How do you select cable size for a given load at a given distance from source of supply. How do you find voltage drop.
How servo stabilizer works.
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What test must you do before powering up a circuit that you have been working on?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
PLEASE ANYBODY HAVE ELECTRICAL CIRCUIT DIAGRAM FOR CHMER PULSE CD 60M SPARKING MACHINE.PLEASE MAIL ME SUPRIYAAYYAPPAN@YAHOO.CO.IN.
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
What is proportional controller?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
