what is difference of electrical and electronics
- 6 Answers
- 5912 Views
- SSIL, I also Faced
- E-Mail Answers
Answer Posted / meenakshi
electrical is field of engineering that deals with high
voltage and high current .i.e, simply telling applications
of high power systems.whereas electronics deals vid mainly
low power applications
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
why do we have spikes enough to burn electronic boards, when generators are not grounded
while starting a liquid starter ,is there any volage drop on water/soda on tank.can we touch the tank on starting?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
any one please tell taht what type questions will be asked in BHEL interview, i am having interview on 24th Dec, please send this to mail pradeepsistam@yahoo.co.in
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
how brushed dc motor operating ?
bsnl tta exam question
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Battery is a voltage source? give one example of current source and why?
how to measure the current by compact digital equipment with dislay which fit inside any equipment
