i want to estabilish an loss energy storage system,such that
it can store electricity lost during the transmission of
electricity in conductor,so that this system stores energy
lost during transmission and supply it to street lights
during night
- 2 Answers
- 3340 Views
- I also Faced
- E-Mail Answers
Answer Posted / abdul karim
1) MY dear friend , if you are qualified electrical , you must know that the losses are NOT due to transmission the losses are due to conductor resistance,If you can make the conductor resistance 0, there will be no loss during transmission
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Explain what is rated speed?
What's the difference between non break power supply and non break non short break power supply
what r the checklist while installing a 380 kva DG set
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
What is the type of earth fault protection used in battery? explain.
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
what ispositive, negative, zero sequence impedence?
What is thresh hold value of current?
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
What is the cut-off rate?
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
