Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between PLC and DCS?
- 4 Answers
- 14484 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / ghazanfar ali
In PLC the Scan time is less.but the scan time of DCS is
high.Because it Control the whole plant. So in safty llop
we used PLC
| Is This Answer Correct ? | 6 Yes | 11 No |
Post New Answer View All Answers
what is piezoelectric transducer?give an example in power plant n state its principle?
how do calibrate the valves.. with clear manual
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
What is the use of each wire in three wire RTD
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
Can I calibrate the Electromagnetic Flow Meter on line and How.
What is difference between Ionization heat and bimetallic heat
How to calibration coriolis flow meter?
defination of radial vibration?
How to Calibrate Vortex Flow transmitter in field
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
any questions on motor and energy conversions machines?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
