why we use to always generate power below 16kv.why not at
higher voltage?
- 3 Answers
- 5147 Views
- I also Faced
- E-Mail Answers
Answer Posted / saravanan.p
Normally, in India, the generating voltages are 6.6 KV,11 KV. Very rarely 22 KV, 33 KV are generating. If generating voltage increases, the cost of alternators, protecting devices abd other equipments are increased.
We can stepped up / down the voltage as we required by using transformers. So minimum generating voltage is efficient and economical.
ersaravananp@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why do we avoid electrical conduits in floors at apartments?
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
How does zener phenomenon differ from avalanche breakdown?
How will polarity test of Dy5 Transformer ?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
distribution transformer de-rating formula on over limit iron losses
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
What do you mean by a current transformer?
what is the difference between 2 way and 4 pole selector switch???
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
primery try cell?
what is high and low cut off voltage of BB and DG at SPS????????
How to design harmonic filter at the project stage without nowing the harmonics levels
What is the function of capacitor in electrical circuits?
