tell me about the instrumentation,what is the actual need
of it ?what are the characteristics of a IC engineer ?
- 11 Answers
- 13379 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / raja
In addition to above pts,
Instrumentation and vital
need is mainly due to need
for
calculative,quantitative,quality,productivity,safety
of any process & so I&C
Engineer does thru
measuring,recording,monitoring
& controlling.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Which type of pressure can be measured by these elements?
how to calculate the total flow in square root
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
Valve positioner and actuators in detail.
Emergency Shutdown Systems/ Plant Shutdown System.
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
what is maxdna ?. explain about the software details.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
What is the GK Value in Flowmeter?
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
KAlman filter code for two dimension?
Conversions
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
which type of signal used in instrument?
