Dear I would like discuss in deep beams problem in design
and serviceability. please contribute to prepare a
comprehensive discussion. first deep beam definition:
- 1 Answers
- 3810 Views
- I also Faced
- E-Mail Answers
Answer Posted / mmh356
Because the geometry of deep beams, their behavior is
different with shallow beams especially they behave as two-
dimensional action rather than one-dimensional action. The
assumption of plane section remain plane cannot be used in
the deep beam design and the shear deformation cannot be
neglected as in the ordinary beam. Thus the load path for a
point load applied at the top of a deep beam will follow a
rather direct path from the loading point toward the points
of support, which appears to depart fairly from that of a
typical bending behaviour for a point load applied at the
top of a shallow concrete member.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is a projection line?
why should we use 20mm graded metal only in vrcc?why we shouldnot use 40mm metal?
What is Base Shear ?
what is mean by reestimation?
What is the outturn of Ceiling plastering
Pls help me to arrive the rates for centering shuttering for highbay using H-frames?
If we are providing concrete joint in every 10m with water stopper in water tank wall then is it necessary to cut the steel at joint section?
Currently my house construction is going on but we just realized that the portico earth beam couldn't connect with the original earth because the beam rod not extended so Please advice
types of piles detail,
What is meant by solid geometry?
What is the value of live load that should be incorporated in design of locker room and cash vault room while designing a building for commercial bank?
qty. of cement & sand required (100sq.mtr) for fixing of floor and wall tiles also fixing of marble stone on the floor
1)Why we can use half brick in 4inch wall and 2)why not in 9+inch brick wall
How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density
What should be the standard roof height like to be?
