Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pawar shyamkant sitaram
It depends upon the system power frequency voltage before
the fault appearing on first pole to the volage appearing
across the heathy poles after clearing the fault. The value
of first pole to clear factor is mainly decided by the
sytem grounding & ratio of zero seq.impdence to positive
sequence impedance.
| Is This Answer Correct ? | 13 Yes | 3 No |
Post New Answer View All Answers
what is ratio of copper wire size and current ?
why constant voltage transformer should be start without load? and if started then what will happen?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
neutral earth resistance testing is it possible for transformer while in load condition
bus bar design conditions and sizing pls tell me quickly
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
why we can use 1 to 5V dc
What is dc current source?
mccb service sittings be done?
What are marginally stable systems?
why you don not show protection and type of isolation in key single line diagram?
we need a ntpc previous papers
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
i have done diploma and btech in EE and live in Chandigarh so kindly help me how can i make my competency certificate in my area.
IN 1000kva transformer where the oil and winding temperature sensors is connected
