How to calculat the size of copper& aluminium wire ?
- 5 Answers
- 10341 Views
- Hindalco, IOCL, I also Faced
- E-Mail Answers
Answer Posted / adil akhtar
we can find the size of conductor either aluminum or copper
by the formula
R = P*l/A
whare R is resistance of conductor
......P is resistivity of conductor
......l is length of conductor
......A is area of crossection
and we can find the length of conductor or area of
crossection by this formula....
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Differentiate between ideal and non-ideal voltage sources?
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What is the physical significance of phase.. i.e. what is exactly the meaning in layman's language.. 1 phase, 3 phase etc ???
How to define Kirchhoff current law and voltage law along with simply examples.
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
What are the special cables required for explosion proof wiring?
how can we select the type of wire.what factors we have to look on it , do we have some formula to calculate it. please guide me on it
what is a bus post insulator? explain its application in a substation.
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
Any one can explaination about calibration with rotating sub standards?
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
How they LT panel busbar size choose
