What are the different ratings of the fuse units for
different distributions at your organization?
Answer Posted / rajendran.m
2A,6A,10A,16A,25A,32A,63A,100A,125A,200A,250A.
Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is the use of bundle conductors?
What are the advantages of vscf wind electrical system?
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
WHAT IS counter flux IN CT?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
explain working principle of earth leakage relay
Explain how you decide what size of electrical wire do you need?
What is the high series capacitance winding on high voltage power transformer ?
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
DERIVE AN EXPREION FOR MAXIMUM POER TRANSMISSION, WHAT ARE ITS APPLICATIONS.
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"