why we used for range in pnumatic 3-15 psi and current 4-20
ma?
Answer Posted / rawjaw
Previous ans is right. But also
refer the answer posted by
others asked same question
by ONGC exams for the very
best answer
Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
how works encoder in plc
How to change dcs card in online. (Dsc is maxdna)
2. What is ultrasonic flowmeter?
Please asked me How calculate DCS controller memory.
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
Why thermo wells are used? What materials are used in thermo wells?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
what is the process to make control schematic ?