Interested to Buy Any Domain ? << Click Here >> for more details...
what would be the earth to neutral voltage in industries? if
it is not main Taine then what will happen?
- 4 Answers
- 6117 Views
- I also Faced
- E-Mail Answers
Answer Posted / n s rathoe
It should be less than 5 volt.If it is not connecting
properly you have faced problem with electronic cards
(specialy low voltage suppy zones criteria)
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
what is positive , negative & zero equivalent system resistance
diff. between tension mode & speed mode
What is the role of Dedicated earthing in UPS System?
how we can set the IDMT relay.
difference bewteen reverse current and alternating current
What is the temperature PROFILE OF A FLUID W. R. T. Distance from a sphere to which it is IN CONTACT which is at constant temp.?
why co incidence factor considered in transformer sizing?
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
how load of a turbo generator can be increased
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
What is meant by vector group
