HELLO FRIENDS plz tell me which are the PROTOCOLS we are
using in PLC
Answer Posted / lalith kumar
RS485
RS232
Ethernet TCP/IP
Profibus
Modbus
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the use of control cable?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
What is force balance principle?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Make Heater Process Logic.
what about your moleg in pogrees with company
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
why using negative supply for bentley nevada vibration system ?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
What is three element drum level control system why its better than single element?
line up procedure for dp type flow transmitter?
What is cut off relay? And why use in PLC and DCS?
Why mmwc unit is used?