How to Calculate the current drain in the battery (1.4V)
for the 2mins time period?
- 7 Answers
- 6937 Views
- I also Faced
- E-Mail Answers
Answer Posted / raafat
it depends on the value of power expending by the materials
as resistor in device that is connected to the battery!!
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
Why can't we parallel Voltage transformer secondary circuits?
how braking & making capacity of circuit breaker is calculated?
i have a 1500kVA transformer what is the kWH meter i need to use?
features of hbc fuses
what is the difference between electrical choke and electronic choke?
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
What is transmittance?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What are the advantages and disadvantages of the dc motors?
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
