Answer Posted / engineer muhammad amin
These cylinders are laid down horizentally to prevent from
leakage because it is very dangerous to handle it if
leakage occurs and also all cylinders are laid down
separatly not over by over other wise there will be chance
of damaging occour and again leaking probability
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
hello everyone do anyone have interview questions for any chemical industry please email me at
What is screen analysis?
Why whenever a reciprocating compressor is switched ON or OFF it is put into unloading mode?
Re: Sugar Cane Bagasse What are the 1. Specific Heat of Bagasse at 50% moisture, 40% moisture and 25% moisture? 2. What is bu;lk density of bagasse at 50% moisture, 40% moisture and 25% moisture? 3. What is specific gravity of bagasse at 50% moisture, 40% moisture and 25% moisture? 4. What is the specific heat of flue gases generated from boiler fuelled by bagasse? 5. What is the specific gravity of flue gases generated from boiler fuelled by bagasse?
how we can find solubility of liquid in amyl alcohol and relative solubility of amyl alcohol
Explain what is a good way to get started in doing a plant-wide steam consumption analysis?
friends....i have been searching the model paper for HPCL officer trainee for chemical eng....tat apptitude section...if u people got any information regarding tat...please send me to my mail...my id is: maruthu.flower@gmail.com...pls send me wtever information u knew....thank u....
Explain about different types of lamps?
Why is post-weld heat treatment sometimes necessary for welded vessels?
Define pneumatic conveying?
What is a good approximation for the heat transfer coefficient of hydrocarbons inside 3/4" tubes?
For amonia manufacturing process if pressure, temperature would be increase over optimum level what would be happen?And what steps should be taken?
What are the different ways in which solids can be blended?
What is the maximum permissible Earth to Neutral voltage in an electrical system.
why 14.7 pound/inch2 is used in idustries as unit of pressure bcz here not sea level and not a temperature is 0C (zero degree celcius)?????????