Thermocouple is a transducer but rtd is not transducer why?
Both taking heat as a input and giving mv
Answer Posted / kamal.sh95
because tc change the temp in mv.and rtd incess the
resistance not change any form of enrgy
Is This Answer Correct ? | 13 Yes | 8 No |
Post New Answer View All Answers
field bus transmitter calibration procedure tell me
what is stroke check for field instument transmetter's & AOV's
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
What is standard procedure of manual mapping in Radar type level transmitter?
How to work temperature gauge?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
what are the steps I have to deal with?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What are the interlocks we have to check during the start up of LP/HP compressor?
How hart protocol can be connected with control valves?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
Why mixer nd grinder Is example of constant torque load not variable torque load ???