one rtd sensor which is connected at middle of distillation
column where actual temp. is 100deg but when we tight this
sensor at thermowell end it goes down to 90 deg & when
remove from the thermowell(but sensor end dipped in well)
showing actual reading, what is reason?
- 3 Answers
- 4769 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashok
The Question is not clear bez always temperature needs time
to reach the actual value like 100deg. so when you take out
of it will not loose the temperature until we take the senor
out.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Explain about the leakage class of the control valves
use of split range ? where it is used ? in which control loop it is used ?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
What is stripper & spilitter ? Diffrence in this.?
how to commission furnace ( water heater)
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
What is furnace draft control?
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
components of control circuit belongs to control valve
Specify for Cables - Flame Retardant and Fire Resistant?
What is difference between Ionization heat and bimetallic heat
What is the reason PT speed not incresed in gas turbine?
why I need valve guard and whats different between guard and positioner ??
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
In turbine what does term CDP, NH, HSSOC means.
