can we light the mercury vapour (tube light)with out a
1).starter and 2).choke in our homes if yes explain how?
- 5 Answers
- 6346 Views
- I also Faced
- E-Mail Answers
Answer Posted / varun
If question is just lighting on then it can be answered as
in three steps:
1.switching on
2.instatntly Switch off
3.again switch on,
This will provide necessary high volatge across lamp
because of transient produced by choke ( a inductor)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
On what basis the the size of Lightning arrester for buildings are selected ?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
How capacitor improves pf
can anybody sent me power grid questions. what subject should i prefer for preparation?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
what is the IPC ? & what the uses ?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
What is acsr cable and where we use it?
What is the approximate value of stacking factor?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
What is the role of power pack in substation protection system?
Can anybody post questions asked in Engineers India Limited Interview? Thanks in advance.
What is center gravity load in substation?
