why is the transmission voltage is multiple of 11?
- 1 Answers
- 4592 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / bishu
as the form factor is 1.11 for a sinusoidal wave
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
orifice sizing how done, checking & selection
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
what is the meaning of osr in transformer.
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
What is the difference between solid grounding and impedance grounding?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
in dc shunt motor if field winding is shorted then
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
What is the dependency of stiffness on load angle??
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
DERIVE AN EXPREION FOR MAXIMUM POER TRANSMISSION, WHAT ARE ITS APPLICATIONS.
WHY RATING OF VCB NOT LESS THAN 630A
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
Enlist four components of electrive drives.
why single phase to grd test in HV cable?why not 2 phase at a time?
