Interested to Buy Any Domain ? << Click Here >> for more details...
what is meant by impedence? can you describe easy becuse
iam not well familier in electrical?
- 2 Answers
- 4485 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhinakaran.s
Impedance describes a measure of opposition to alternating
current (AC). Electrical impedance extends the concept of
resistance to AC circuits, describing not only the relative
amplitudes of the voltage and current, but also the
relative phases. When the circuit is driven with direct
current (DC) there is no distinction between impedance and
resistance; the latter can be thought of as impedance with
zero phase angle.
The symbol for impedance is usually and it may be
represented by writing its magnitude and phase in the form .
1.The magnitude of the complex impedance is the ratio of
the voltage amplitude to the current amplitude.
2.The phase of the complex impedance is the phase shift by
which the current is ahead of the voltage.
3.The ratio between resistance and Reactance.
SI unit is Ohm.
In AC circuit, Z=V/I Ohms.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
quantizer means?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
Define reserve-generating capacity?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
what is the value of combined earthing in general electrical circiut?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
what is the difference between electrical choke and electronic choke?
what is the difference between pvc & fiber glass cables
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
Difference between low impedance and high impedance Restricted Earth Fault
