Answer Posted / gaurav tripathi
auto transformer is the transformer in which only one
winding is used and output is found by changing the tapping
of the winding
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
in shunt clippers why a resistor is used in sereis with the input
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
Can clean earth cable be considered as low current cable
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
Explain and give examples about VCB?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
upto how many load can v connect to stabilizer which is used for tv
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
What is different between Circuit breaker and Isolater?
What is different between Difnit time and instatous over current relay
