why onlyseries motors are used as universal motors? why not
shunt?
- 4 Answers
- 9493 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / md.asaduzzaman
as in series motor torque proportional to flux.current
&flux=current
so,t=i^2so,in ac &dc alws,t=+ve.
and also high starting torque,
but in shunt t=i
as,flux cnst,flux depends on sply voltagein ac it =-ve
so.alws series motor is used.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
What is George phenomena to start the synchronus machine?
What is distance between electrical panel to land ?
What is knee point voltage?
What is the operating principle of turbo-generator.
where are the circulat the diesel in DG parts name with pictue
What current flows in the transformer primary when its secondary is open?
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
how ct burden,magnetising current,ratio and knee point voltage are related & derived
Why the output of OP-AMP is always less than Vcc?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
what is earth resistance? how to measured? and give values at power station and mcc area?
