Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the rating of ELCB OR RCCB for an
equipment?
- 2 Answers
- 23955 Views
- I also Faced
- E-Mail Answers
Answer Posted / renjith nk
for elcb the margine value is 2% of system voltage.
for rccb the margine value of current is 10mA.
| Is This Answer Correct ? | 27 Yes | 13 No |
Post New Answer View All Answers
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
for what purpose the star point is done in ct
Can i use the B-curve MCB instead of C-curve MCB
What is mean by STUB protection?
WHAT IS VCB SAFETY
Testing report of Earthing of 3.15 MVa PTR.
Why corona leads to production of Ozone and glow of the color VOILET?
Draw torque - speed curve and load curve of induction motor? mark operating point ?
how can we find thae value of capacitor for single phase motor. what is difference between starting capacitor and running capacitor.
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What is block diagram?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
