what is the use of starter in tube light?and what it
contains
Answer Posted / bhusani saikrishna
Tube light need
nearly above
1000v across
the two end
terminals .but
our supply
voltage is only
230 v.so we
need to step up
the
voltage.this
step up of
voltage is done
by the choke by
the process
called
selfinduction
and this
selfinduction
to happen
startor help
the choke.
Is This Answer Correct ? | 12 Yes | 7 No |
Post New Answer View All Answers
What is q factor?
which protection used in power plant?
how line turns ratio changes in 3 phase with change in connection
What is the difference between Droop vs Isoch Control?
How to calculate the fuse rating depend upon the DC circuit?
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
why the carbon brushes are broken in srim while the motor runningtime
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
can anybody sent me power grid questions. what subject should i prefer for preparation?
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
What is the purpose of stablization resistor in high impedance bus bar protection
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
Is a d.c.compound motor is use as a booster? how?