why Transformers power mentioned in KVA?. and why Generators
and Motors power mentioned in KW?.
- 10 Answers
- 11945 Views
- I also Faced
- E-Mail Answers
Answer Posted / yogesh
Transformer and genrator PF depends on the nature of
connected load ( Motor ), But motor has its own fixed Power
factor
Therefore Transformer and genrator capacity shown in KVA (
Without PF ) and motor Capacity shows in Kw ( with power
factor )
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
What is the application of Dyn1 and Dyn11 vector group of transformer?
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
How to Make relay co ordination chart for a Electrical power distribution of a plant
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
Sir, I have applied for the of Jr.engineer(Electrical & Electronics) & ASST. LOCO PILOT at ALL RRB BOARDS. please send me all RRB Boards solved papers in the year of 2001 tO till date. i requested send me the papers to my id as soon as possible (jet_0991@yahoo.com). (This is very urgent) Thank You,
What are the specifications for getting approval of Substation?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
What is the magnetic field (coil DC ) of Turbo Expander?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
why is control bus bi-directional?
state types of reflectors in illumination engg. ???????
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
