what is ground clearence ,what is minimum ground clearence
,i.e present value following in india ,is it changes wit
conductor size ,kva rating.surface
- 3 Answers
- 7518 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The minimum ground clearance depends upon voltage
only.1)Across the road a)low and medium voltages- 5.8mt
b)high- 6.1 mt2)Along the road a)5.5 mt b)5.8 mt 3)
Elsewhere a)low,medium high voltages up-to 11 KV ,if bare
-4.6 mt 2) if insulated- 4mt c)for high voltages above 11 KV
-5.2 mt 4)extra high tension 5.2 mt + 0.3 mt for every 33 KV
or part thereof by which the voltage exceeds 33KV,provided
that the minimum clearance along or across the road shall
not be less than 6.1 mt .Low voltage - up-to 250,medium
-up-to 650,high-up-to 33KV ,extra high -above 33 KV. Ref IE
Rules 1956
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What are the different losses In a de mac1une'! t.xplam
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
700KW 6.6KV slip ring induction motor to use VFD to control the speed
How many types of electrical earthing are there?
What is meant by analogous system?
Write down the design procedure of commutaj.
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
why the name trunking bus PT
what is the difference between earthing and unearth
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
What is open delta Xformer? It's adavntages & Use?
