why we are not earthing ht cable at both the ends(sending &
receiving end)?
- 5 Answers
- 12022 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / vinod
HT cable earthing only sending end, Why because in case of
earth fault relay pick up with minimum leakage.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
Draw the line diagram of diffretial relay connected to transformer?
what is physical distance of isolator to VCB in 33/11kv sub stations
how to set the time in digital timer ?
What is vaccum currcuit breaker.define with cause and where be use it device?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
what is interpose? where it is used and why it is used?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
compare between starting charactristics of synchronous motor with those of 3Q Squirrel cage induction motor
Draw a SLD of DG distribution up to main LT panel?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
How stabilizer works??
