what is materal used for piston in IC engine& why?
- 16 Answers
- 18114 Views
- NTPC, ONGC, I also Faced
- E-Mail Answers
Answer Posted / naveen kumar kaushal
it's Al because it is having less weight as compared to cast
iron.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how much capacity of id fan for 200HP induction motor
What are to be checked in an induction motor?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
What type of gear is the first reduction gear pinion?
Which is the hardest material on earth?
What do you analyze from boiler water analysis?
what is first law of Thermodynamics ? What is second law of Thermodynamics ?
What is orthographic drawing?
in regenrative cycle why to use two liquid(water&mercury) on steam genration cycle.
Dear Sir, I am Shariq Sami. I joined BHEL as a Supervisor Trainee in May 2009 on diploma basis, right now i am an assistant Engineer and posted at Noida. I have completed my bachelor of engineering from Jamia Millia Islami, New Delhi.I am Planning to appear for "BHEL ET" exam this year. I want to know,is there any previous year question papers will be available like we have for GATE exams or you feel it is no need? Can you please guide me? Kind Ragards M.S Sami, Contact No. 9891090742, 9250250988, 0120-2545796
Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?
What school did you attend in engineering?
Write down the equation for conduction of heat through a slab or plane wall.
List out the points of diesel generator B check?
hello sir iam atul joshi from mechanical branch. i want to know about the syllabus of technical ques of jindal steel
