Interested to Buy Any Domain ? << Click Here >> for more details...
why using in cable mm square which is mm & which is square
why using mm & square.
- 1 Answers
- 4610 Views
- Airtel, I also Faced
- E-Mail Answers
Answer Posted / sri
cable diameter measured in the cross sectional area of the
conductor. the unit is mm square. the current carrying
capacity of the cable is directly proportional to cross
sectional area.
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
What is meant by reactance voltage?
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
what is dry and wet frequency withstand voltage? why & where it is used??
define reflection method?
What happens to voltage when current is zero?
What is the difference between DOL starter and star delta starter
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
Define the overload capacity of the motor?
1 Ton is equal to how many watts?
What is the lower limit of break-down voltage of converter transformer.
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
