phase colour is indicated by R Y B (red yellow blue) but in
transformer i have seen U V W instead of (R Y B) have any
meaning of this
Answer Posted / sanjay kumar singh
bcoze u v w are the motor or transformer terminal
| Is This Answer Correct ? | 12 Yes | 7 No |
Post New Answer View All Answers
Define the term factor of inertia.
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
how many single tension hardware are required on a double circuit transmission tower?
how to test and calculat the head and discharge in borewell compressor
What is the emf equation of a transformer?
How to decide DO set rating of Transformer?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
electrical knowelge
What it the purpose of parallel phasing transfomers??
how solar power plant energy meter multiplication factor
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
How can we calculate cable size in Low voltage & high voltage