what is the working principle of ceiling fan and table fan?
- 10 Answers
- 45077 Views
- ABC, Tata Steel Limited, I also Faced
- E-Mail Answers
Answer Posted / shivkumar
The working principle of ceiling fan:-ceiling fan in which
split phase motor. It is work on mutual induction.
The working principle of table fan:-table fan has a split
phase motor.& also work on mutual induction.
mutual induction:-when stater connect on ac supply,stater
produced rotating magnetic flux.this flux cut with rotar.by
air gap.& produced rotating magnetic flux in it.
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
2. What are the parameters of EHT sub-station?
define the active power?
what is the difference between STAR and DELTA connection and application wise how it can be utilizedd
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
Mention the disadvantages of low power factor?
why high speed tripping relay is used in protection circuit why not normal relay
Why line VTG = √3 phase VTG in star? How?
why different series of vfds (like allenbradley)are used in industry ?
what is the difference between changer, converter and transformer?
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Do you need any help with FEWA Electrical Supervisor exams?
what is the difference between elcb and rccb ?
