Answer Posted / singa
Neutral is a conducter used as return path.
It is having low potential compared to phase.
Whereas an earth is haivng zero potential
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
What are the advantages of nichols chart?
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is icu and ics in Acb and how many time icu or ics passes from breaker?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
Differentiate between low pass, high pass and band pass filter?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What should be the height of basement according to NBCC code?
what is the difference between c power and U power acb breaker
