Answer Posted / qazi a. alam
the colour is just a formality. main thing is to balanco
the load on all the three phases.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what is the difference between torque induced and torque load?compare them with respect to dc motor?
What is domestic transformer? Draw the connection of domestic transformer.
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
What is transient Phenomenon?
What is inrush current?
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
Comment on the working principle of operation of a single-phase transformer.
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
why power factor is important?
how you configure motorvision relay (L&T make)from DCS
What is size 00, 01, 1 etc., in HRC fuse types?
