Why the starting current in Induction Motor is very high as
compared to normal rated current ????
- 6 Answers
- 15293 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / avd
Dear, Back EMF is not present during starting (till rotor
achieves its speed) Hence starting curent will be high. You
can consider motor as a secondary shorted transformer
during starting. Hope it is clear now...
| Is This Answer Correct ? | 18 Yes | 4 No |
Post New Answer View All Answers
How to size fuse? How to size MCB?
What are the different circuits in thermal power plant?
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
what is per unit calculation?looking for simple and strong explanation thk u
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
what is the difference between rectifier and converter and commudator?
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
if i am in front of transmission line how to know that current direction without any equipment
What is the actual calculation for transformer short circuit test?.
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
