Answer Posted / ksnmurthy
relay is having normally close normally oepn contacts are
there so operation wise we can use relay by switching on
and off according to circuit
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is the meaning of neutral displacement ???
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
difference between high and low impedance BUS BAR relay??
how are reversing the direction of dc motor
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
Is it possible to connect a safety device in to parallel?
what things to be considered when designing UPS
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
what & how to check the lightning arrester
What is difference between slip rings and carbon burushes?
state the working of discharge lamp?
